Structure in AISI 304 stainless steel sheet, brushed finish. Insulation made with polyurethane foam panels. Upper tank with separate compartments, GN 3/1 capacity, molded and without sharp edges, suitable for GN containers up to 20 cm (not included). Temperature controlled by digital thermostat-thermometer, maximum 90 °. Heating by dry resistances placed under the tank, power 1350W. Possibility of using both dry and bain-marie. Hole for draining the water on the bottom of the tank, water bath drain tap. 3 separate lower compartments, 3 hot, meet the H1 standard, independent, each one complete with 6 pairs of printed guides, 5.5 cm pitch, for the insertion of GN 1/1 containers. Voltage mains 230 Volt single-phase-50/60 Hz., Total power 2550W. Spiral feeding cable, 3 meters long (without plug). Push handles isolated. Perimetrical bumpers in gray non-marking rubber. Wheels Ø cm 16 with heavy support, two fixed and two swivel with brake, gray rubber ring non-marking and rolling on roller bearings, thread guards.